SM Modellbau - Ignition switch 3

SKU: 235493

Category: ignition switch 3

HAN: 1010
HAN: 1010

Der Zündschalter 3 ist zum Ein- und Ausschalten von elektronischen Zündungen bei Benzinmotoren per Fernsteuerung entwickelt worden.

42,90 €

incl. 19% VAT , plus

Available immediately
geringer Lagerbestand

Lieferzeit: 1-2 Werktage

piece

Available immediately
geringer Lagerbestand

Lieferzeit: 1-2 Werktage

The ignition switch 3 has been developed for switching on and off electronic ignitions in gasoline engines by remote control.
New to the ignition switch 3 is the possibility to operate it in parallel with the throttle servo. That is, the Zündschalter 3 is connected to the gas channel of the receiver, the throttle servo in turn at the Zündschalter 3. Thus, a receiver output can be saved!

For this purpose, the switching point and the switching direction can be taught in as desired. So you can achieve that the ignition is switched off at idle by reducing the gas trim.

In addition to the two built-in control LEDs, an external LED is now also supplied, which can be connected to the ignition switch 3. This is then mounted in the fuselage wall and allows easy control of the switching status.

The Zündschalter 3 is the in all respects überlegene replacement für the previously used mechanical switch:

no wear;
Elegant engine shutdown from the remote control
great safety improvement in conjunction with the receiver's fail-safe function: in the event of a malfunction, the motor can be safely shut down and no longer pose a danger
naturally, the ignition switch is just as suitable for switching lights or other consumers

The Zündschalter 3 is microcontroller-controlled and has ügt an optocoupler for the complete separation of the two circuits receiving system - Zündung. The circuit has various fail-safe features, which ensure that in emergency cases the ignition is switched off safely.
If the ignition is switched off, the ignition switch does not consume any current from the ignition battery. The plug connection to the Zündakku must be separated thus only for charging. Alternatively, you can also charge via a separate charging socket and the ignition switch 3 always remain plugged into the battery.

Technical data: