RC factory - Veloxity red 14mm EPP - 1070mm

RC factory

RC factory - Veloxity red 14mm EPP - 1070mm

SKU: 313616

Category: RC factory

Manufacturers: RC factory
HAN: T93R

Die Veloxity wahrt ihre hohe Präzision in vollem Umfang.

139,90 €

only

137,10 €

incl. 19% VAT , plus

Available immediately
nur 1 Stück lagernd!

Lieferzeit: 1-2 Werktage

piece

Available immediately
nur 1 Stück lagernd!

Lieferzeit: 1-2 Werktage

The new Veloxity was designed by the mastermind Cody Wojcik!

Like the design of the man-carrying Velox Revolution 1, the Veloxity delivers a flying performance never before achieved with an EPP model.

The extremely stiff construction makes flight figures possible which are normally reserved for wooden planes, such as extreme roll rates, extreme tracking, tumbles, knife spin, and much more.

The Veloxity is probably the best trainer for all possible roll figures due to the constant roll rate and extreme tracking. The Veloxity is especially suitable for throttles and is perfect for all 3D maneuvers. A carefully selected profile, as well as the length ratios ensure that Harriers can be flown stable and clean in normal and roll positions;The aerodynamic and structural design is matched by a tried and tested electronics set. The optional set includes a 370W T-engine, 12x6 propeller and a 45A regulator. The new ICE servos with aluminium tubes and metal gears provide good repeatability at high speeds and high power. From 3S 1300mAh to 2200mAh, the Veloxity covers the entire spectrum from easy flying to 6 minutes of hardcore 3D action.

The construction of the Veloxity is simple. The precisely manufactured foam, wood, carbon and glass fibre parts allow quick and precise installation in prefabricated cut-outs and recesses.

The Veloxity is as easy to build as an 800mm Shockflyer and is ready to fly in just a few hours. The rudders are controlled by ball-and-socket joints, which ensure high precision when flying and a servo-protecting jump-off of the connection in the event of a crash.

The Veloxity is also ideal for beginners and advanced pilots. With slightly reduced deflections it flies tame and beginner friendly. The Veloxity is the perfect transition between Shockflyers and Balsaflugzeuge and the structure does not leave you in the lurch, even during heavier landings or ground briefings.

With the Torcster drive set L the model delivers enough power, if you like power, the XL drive set is the best choice.
After some tests the Aeronaut Cam light 12x5 turned out to be ideal. Thus approximately 32A run in the point by the system (with 3s/1800/45c) - which makes with full Akku approximately 370 Watt - and thus the recommendations of the manufacturer correspond. So the Veloxity can also rise from Torquerollen zügig - and there is always enough Punch there! The flight time is reduced to (sufficient) 8 minutes (with the small Torcster on an 11x4.5 about 12min - but only about 250 watts - and correspondingly less steam). The APC 11x5.5 delivers slightly less draught. The controller in 30A is sufficient here, too! The heavier motor from the XL set shifts the battery position towards the centre of gravity.

Technical data:

span: approx. 1070mm
departure weight: ca. 550g
Length: approx. 1.120mm
Benötted controller: brushless 35A to 45A
Benötied servos: 4x 12g
Benötat drive battery: 1350mAH to 2200mAh 3s
material thikness: 14mm EPP