Jeti - Central Box 320 (mit 2x Rsat 2 und RC-Switch)

Hacker Motor

Jeti - Central Box 320 (mit 2x Rsat 2 und RC-Switch)

SKU: 343313

Category: Jeti

Manufacturers: Hacker Motor
HAN: J-CB-320-RS-RCSW

533,90 €

incl. 19% VAT , plus

Lager Lieferant

Lieferzeit: Must be ordered. Ready for shipment in 3-6 days after order.

piece

Lager Lieferant

Lieferzeit: Must be ordered. Ready for shipment in 3-6 days after order.

The Central Box 320 is designed for comprehensive management of multiple servos and two receiver batteries for a model with high safety requirements. The Central Box 320 has overload protection on each servo output, 8 channels for high power servos up to 60Kg/cm and 10 channels for standard servos up to 30Kg/cm. Especially for the use of even powerful and power-hungry servos, the Central Box 320 uses an aluminum housing for better cooling. The Central Box 320 offers true battery redundancy, DITEX servo telemetry, JETI EX telemetry and up to three receiver inputs (2x 2.4GHz and 1x 900MHz) for complete power and RF signal redundancy.

Configuration via JETI Duplex DS/DC Transmitter
With JETI Duplex DC/DS transmitters the full potential of the Central Box 320 can be used. Via the device overview of the JETI Duplex DS/DC transmitter, the entire configuration of the servo outputs, DITEX servo as well as JETI EX telemetry, function assignment, etc. can be done very easily.

Compatibility with Futaba S.Bus
The Central Box 320 can also be used with two S.Bus receivers (e.g. Futaba R7003SB). However, settings and reading of telemetry values must be done via a separately available JETIBOX.

Switching on and off
The switch-on and switch-off procedure of the Central Box 320 is carried out with the supplied magnetic switch transmitter.

Recommended receivers
2 RSat2 or REX3 receivers can be used as receivers. Optionally, the use of a REX Assist receiver together with a RSat2 receiver is possible, so you get a Central Box with gyro stabilization.

Features:

Adjustable powerful BEC for voltage stabilization(connection of standard or HV servos).
DITEX servo telemetry support
Possibility to connect up to 3 receivers with serial communication
built-in expander function with the possibility of independent connection of up to four JETI EX sensors
Input for magnetic switch or RC switch
power supply batteries connected via MPX connector
100Hz mode of servo outputs (10ms period)
EX telemetry support (measurement of voltage, current, capacitance, temperature, etc.)
Easy setting changes via DC/DS transmitter ("Device Explorer")
Rugged metal construction with mounting holes

Technical data: