FMS - Chevrolet K10 red - RTR 2.4GHz - 1:18

FMS

FMS - Chevrolet K10 red - RTR 2.4GHz - 1:18

SKU: 386931

Category: crawler

HAN: DPFMS11851RTRRD
GTIN: 784085200653
HAN: DPFMS11851RTRRD

189,00 €

incl. 19% VAT , plus

Currently out of stock

piece

Currently out of stock

The FCX18 Chevrolet K10 is an officially licensed crawler on a scale of 1:18. The scaler comes with a 2-speed gearbox, built-in electronics, integrated lighting, remote control and battery ready to drive out of the box.

100% Scale
The model is officially licensed by General Motors. From the two-tone, true-to-original paintwork, the radiator grille, the hinged tailgate on the loading area to the controllable lighting and the simulated bevel gear drive axles - every detail of this scaler is just right. The tailgate can be opened so that various 1:18 scale components, such as motorcycles, kayaks and various camping equipment, can be stowed away. The spacious compartment concealed under the hood provides a clear view of the electronic components, making routine maintenance easier.

Masters any terrain
To faithfully reproduce the off-road capability and handling of the original vehicle, FMS has made remarkable progress by deriving the FCX18 chassis from the FCX24 series chassis. The FCX18 chassis features a metal beam construction as well as metal beams (4 pieces) and steering rods (2 pieces) that perform even under extreme conditions. The mid-mounted drive unit has a low center of gravity and includes a 2-speed gearbox, a transfer case and a 180cc brushed motor
The power is transmitted to the front and rear axles via the cardan shaft. The axles are equipped with wheel side reducers, commonly referred to as "portal axles", which increase the ground clearance of the differential gear group and improve driveability.
The FCX18 is fitted with a straight axle as standard, but the planetary differential can also be replaced with high viscosity silicone oil to simulate the drive effect of an LSD limited slip differential. After installing the differential, the ultimate climbing ability is reduced, but a smaller turning radius and more stable handling at high speeds are achieved.

2-speed gearbox
The two-speed gearbox can be shifted via the 3rd channel of the remote control and is operated via a 9g servo. The low reduction ratio is 99 and the torque is very high and suitable for extreme gradients. The high reduction ratio is 24.75, allowing relatively high speeds to be achieved.

Built-in electronics
The waterproof electronics consist of a powerful brushed motor, two independent servos, a 3-in-1 receiver/controller/light control unit and a 2S (7.4V) 900mAh LiPo battery. The complete electronics are already integrated and connected in the model, so that the Chevrolet K10 can be launched immediately after unpacking.

Features:

1:18 scale scaler with 4WD drive
officially licensed by General Motors/Chevrolet
2-speed gearbox switchable via remote Control
Portal axles with metal gears
Low metal rods (4 pcs.) and steering rods (2 pcs.)
Four-link suspension
Large all-terrain tires with special chrome-plated wheel hubs
Rigid metal carrier
-Completely mounted on ball bearings (24 pcs.)
Functional spare tire
Steering servo with metal gearbox
Coil springs and metal oil pressure shock Absorbers
3-in-1 receiver with 20A controller and light Control
Integrated lighting system with headlights, tail lights and indicators - several modes switchable via remote control
Hinged Hood
Hinged tailgate
-Painted Body
High-traction tires
Optional conversion parts such as metal differential, metal PTO, metal gears, brass wheel counterweights and trailer available separately
Waterproof electronics
2.4 GHz remote control included
Includes 7.4V 900mAh LiPo battery for up to 30 minutes of driving time
Includes USB charger for the battery

Technical data:

Length: 336mm
Width: 139mm
Height: 139mm
Wheelbase: 199mm
round clearance: 40mm
Tire diameter: 35mm, T 14.1mm
scale: 1:18
-Motor: Brushed 180
Servo: 1x Digital 13g MG, 1x Digital 9g PG
Receiver/controller/light unit: 20A
2.4GHz remote control
Driving time per battery: approx. 45 minutes

Manufacturer information:

PICHLER Modellbau GmbH
Lauterbachstrasse 19
Bayern
Eggenfelden, Deutschland, 84307
mail@pichler.de
https://www.pichler.de